Contact Us
NingBo Dacheng Machinery & Electrical Co.,Ltd
Add: No.157 Shangyang Road, Yinzhou Area, Ningbo, Zhejiang
Contact Person: Mr Chen
Tel: +86-574-88232682
Tel: +86-574-88232883
Tel: +86-574-88232799
Mobile: +8613605884383
Fax: +86-574-88233109
Emaill: nbdc@dachengmotor.com
Home > Knowledge > Content
Introduction to the use of electric grinder
Aug 10, 2018

Introduction to the use of electric grinder:

(1) The thickness of the grinding wheel should be selected according to the material to be processed and the processing progress requirements. For softer metal materials, such as copper and aluminum, thicker grinding wheels should be used, and those with higher machining accuracy should be used with thinner grinding wheels.

(2) Select the appropriate grinding wheel surface according to the shape to be processed.

(3) The grinding wheel used shall not have defects or disability such as cracks and defects, and the installation must be stable. At this point, you should always pay attention to the use of the machine, if you find defects or disability such as cracks, defects, etc., immediately stop using and replace the new product; when you are active, you should immediately stop and tighten.

(4) When grinding, operators should wear protective glasses and gloves to prevent splashing metal chips and sand from harming the human body.

(5) The pressure applied to the grounded device should be appropriate. If it is too large, it will cause overheating to anneal the machined surface. In severe cases, it will not be used, and the life of the grinding wheel will be too fast.

(6) For devices with a width smaller than the grinding surface of the grinding wheel, do not always grind one part of the grinding wheel during the grinding process. The grinding wheel should be translated to the left and right at a certain cycle for the purpose of grinding the grinding wheel. The noodles can be kept relatively flat for future processing.

(7) In order to prevent overheating and annealing of the machined surface of the machine to be ground, the grinding part can be cooled in deep water at any time.

(8) Regularly measure the insulation resistance of the motor, and ensure that it is not less than 5MΩ.) Use a circuit breaker with a leakage protection device to connect to the power supply.

150w-mini-bench-grinder26151394031.jpg

Previous: How to troubleshoot the grinder?

Next: What should I do after the AC MOTOR gets wet?